ESNQS 4-канальный диммер 0-10В для установки на DIN-рейку (QSNE-4T10-D)

Power Module

The Power Module family is a group of modular products for the control of lighting loads. This document describes the following products:

• Model Number: LQSE-4S10-D - Power Module unit for Switching only

• Model Number: LQSE-4T10-D - Power Module unit for 0-10 V/Switching

Features

• Includes QS link for seamless connection to a HomeWorksR QS system.

• Power Module units can be used in a HomeWorksR QS system to control and manage light in an entire home or building.

Power

• 230 V 50/60 Hz

• Lightning strike protection meets ANSI/IEEE standard 62.31-1980. Can withstand voltage surges of up to 6 000 V and current surges of up to 3 000 A.

• Current draw: 50 mA max

• Standby power : 1 W

• BTUs/hour when fully loaded: 4

Output Zone Ratings

• Each zone is rated at 10 AX for switching. Rated for resistive, capacitive, or inductive lighting loads as defined by IEC/EN 60669-2-1.

• Switched outputs utilize latching relays to maintain relay state if control power is lost.

• 0-10 V rated for 50 mA maximum output, source or sink per zone.

Terminals

• Mains wiring: 0,5 mm2 to 6,0 mm2

• 0-10 V Wiring: 0,5 mm2 to 2,5 mm2

• CCI Wiring: 0,5 mm2 to 6,0 mm2

• Zone wiring: 0,5 mm2 to 6,0 mm2

Mounting

• Use an IP20 (minimum) rated consumer panel or breaker panel with integrated DIN rail

• Width = 9 modules (161,7 mm)

Programming and Compatibility Requirements

• LQSE-4T10-D and LQSE-4S10-D can only be used with the HomeWorksR QS system.

• Setup and programming of the DALIR Power Module is done through the HomeWorksR QS programming software.

• HomeWorks® QS software version 3,0 or higher required.

QS Link Limits

• A QS link in a HomeWorksR QS system can have up to 512 zones (outputs) and 100 devices.

• Each Power Module counts as one device toward the 100 device limit.

Manual Mode Operation

• Zone buttons: — selects zone to control

• Raise/Lower buttons: — turns loads on and off — dim loads up and down (LQSE-4T10-D only)

0-10 V Wiring

(LQSE-4T10-D only)

• 0-10 V zones 1-4 are double-insulated from all other inputs and outputs.

• 0-10 V zones 1-4 are not insulated from each other. They share the same common (negative “–” terminal).