Корпус низковольтный LUTRON (L-LV14-230)

Low-Voltage Enclosure

Low-Voltage Enclosure Low-voltage enclosures may be surface-mounted in an electrical closet or equipment room. Both the number of enclosures and the types of components within them are customized to fit the size, lighting plan, and design of a home. Low-voltage enclosures can be distributed throughout the home near the rooms they are controlling, to provide maximum flexibility during installation of the low-voltage wiring. Low-voltage enclosures cannot house Remote Power Modules (RPMs).

14 in (35.6 cm) Low-Voltage Enclosure

The 14 in (35.6 cm) low-voltage enclosure provides a compact housing for mounting one processor or one system interface and up to two wire landing boards (QS-WLB). The enclosure accepts one 120 V~ (L-LV14-120) or 220-240 V~ (L-LV14-230) feed to power the panel, which is self-contained in an enclosed area, thus allowing access to only the low-voltage connections when the enclosure cover is removed.

Power

220-240 V~ 50/60 Hz 1 A (L-LV14-230)

Environment

Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C) Ambient operating humidity: 0% to 90% humidity, non-condensing. Indoor use only.

Mounting

Enclosure may be surface-mounted. Mount the enclosure so that line-voltage wiring will be at least 6 ft (1.8 m) from audio or electronic equipment and wiring.

Mount Enclosure using the following method (mounting hardware is not provided):

Surface Mount – Use keyholes with bolts sufficient for 100 lb (45 kg) load, 0.25 in (M6) bolts recommended.

NOTICE: This equipment is air-cooled. Mount in a location where there is at least 12 in (305 mm) of clearance in front of the enclosure.

NOTICE: Power supply will hum slightly and internal relays will click while in use. Mount in a location where such noise is acceptable.

Dimensions

Enclosure: 13.3 in (337 mm) x 9.2 in (235 mm) x 3.16 in (80 mm)

Cover: 13.32 in (338 mm) x 9.32 in (237 mm)

Construction

Enclosure: 16-gauge powder coated sheet metal. Cover: 16-gauge powder coated metal cover. Cover is attached using four phillips-head screws.